lspci -nnk

02:03.0 Ethernet controller [0200]: 3Com Corporation 3c905C-TX/TX-M [Tornado] [10b7:9200] (rev 74)
	Subsystem: 3Com Corporation 3C905CX-TX/TX-M Fast Etherlink for PC Management NIC [10b7:1000]
	Kernel driver in use: 3c59x
	Kernel modules: 3c59x

lspci -vmmnn

Slot:	02:03.0
Class:	Ethernet controller [0200]
Vendor:	3Com Corporation [10b7]
Device:	3c905C-TX/TX-M [Tornado] [9200]
SVendor:	3Com Corporation [10b7]
SDevice:	3C905CX-TX/TX-M Fast Etherlink for PC Management NIC [1000]
Rev:	74

lspci -vvnnk

03:02.0 Ethernet controller [0200]: 3Com Corporation 3c905C-TX/TX-M [Tornado] [10b7:9200] (rev 74)
        Subsystem: 3Com Corporation 3C905CX-TX/TX-M Fast Etherlink for PC Management NIC [10b7:1000]
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
        Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
        Latency: 32 (2500ns min, 2500ns max), Cache Line Size: 32 bytes
        Interrupt: pin A routed to IRQ 23
        Region 0: I/O ports at ec00 [size=128]
        Region 1: Memory at febffc00 (32-bit, non-prefetchable) [size=128]
        Expansion ROM at febc0000 [disabled] [size=128K]
        Capabilities: [dc] Power Management version 2
                Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0+,D1+,D2+,D3hot+,D3cold+)
                Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=2 PME-
        Kernel driver in use: 3c59x
        Kernel modules: 3c59x

01:04.0 Ethernet controller [0200]: 3Com Corporation 3c905C-TX/TX-M [Tornado] [10b7:9200] (rev 78)
	Subsystem: Hewlett-Packard Company 3c905C-TX/TX-M [Tornado] [103c:1246]
	Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
	Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
	Latency: 80 (2500ns min, 2500ns max), Cache Line Size: 32 bytes
	Interrupt: pin A routed to IRQ 5
	Region 0: I/O ports at 2000 [size=128]
	Region 1: Memory at ec100000 (32-bit, non-prefetchable) [size=128]
	Expansion ROM at 10000000 [virtual] [disabled] [size=128K]
	Capabilities: [dc] Power Management version 2
		Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0+,D1+,D2+,D3hot+,D3cold+)
		Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=2 PME-
	Kernel driver in use: 3c59x
	Kernel modules: 3c59x

hwinfo

20: PCI 104.0: 0200 Ethernet controller
  [Created at pci.386]
  Unique ID: ZSLl.RIV7npLCdHC
  Parent ID: 6NW+.mCtu7+mpnF0
  SysFS ID: /devices/pci0000:00/0000:00:1e.0/0000:01:04.0
  SysFS BusID: 0000:01:04.0
  Hardware Class: network
  Model: "3Com 3c905C-TX/TX-M [Tornado]"
  Vendor: pci 0x10b7 "3Com Corporation"
  Device: pci 0x9200 "3c905C-TX/TX-M [Tornado]"
  SubVendor: pci 0x103c "Hewlett-Packard Company"
  SubDevice: pci 0x1246 
  Revision: 0x78
  Driver: "3c59x"
  Driver Modules: "3c59x"
  Device File: enp1s4
  I/O Ports: 0x2000-0x2fff (rw)
  Memory Range: 0xec100000-0xec10007f (rw,non-prefetchable)
  Memory Range: 0x10000000-0x1001ffff (ro,non-prefetchable,disabled)
  IRQ: 5 (30 events)
  HW Address: 00:01:03:09:0a:3d
  Permanent HW Address: 00:01:03:09:0a:3d
  Link detected: yes
  Module Alias: "pci:v000010B7d00009200sv0000103Csd00001246bc02sc00i00"
  Driver Info #0:
    Driver Status: 3c59x is active
    Driver Activation Cmd: "modprobe 3c59x"
  Config Status: cfg=new, avail=yes, need=no, active=unknown
  Attached to: #14 (PCI bridge)