Home » Hardware » tarjetas de ethernet » Intel Corporation 82557/8/9/0/1 Ethernet Pro 100 (rev 08)
tarjeta de ethernet Intel Corporation 82557/8/9/0/1 Ethernet Pro 100 (rev 08)
modelo: Intel Corporation 82557/8/9/0/1 Ethernet Pro 100 (rev 08)(id del modelo: 364)
otros posibles nombres del dispositivo:
82557/8/9 [Ethernet Pro 100]
NC3134
fabricante:
Intel Corporation
código VendorID:ProductID del dispositivo:
8086:1229
año de comercialización:
2005
interfaz:
PCI
probado con:
Parabola GNU/Linux
probado con el siguiente kernel libre:
5.3.8-gnu-1
¿funciona con software libre?
si
driver libre usado:
e100
Descripción:

It works but needs firmware blobs for the CPUSaver feature, maybe it depends on the other driver (eepro100), which is missing in the libre kernel?

lspci -vvnnk

04:05.0 Ethernet controller [0200]: Intel Corporation 82557/8/9/0/1 Ethernet Pro 100 [8086:1229] (rev 08)
        Subsystem: Compaq Computer Corporation NC3134 Fast Ethernet NIC (dual port) [0e11:b163]
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
        Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
        Latency: 32 (2000ns min, 14000ns max), Cache Line Size: 32 bytes
        Interrupt: pin A routed to IRQ 20
        Region 0: Memory at febfe000 (32-bit, non-prefetchable) [size=4K]
        Region 1: I/O ports at e880 [size=64]
        Region 2: Memory at fe900000 (32-bit, non-prefetchable) [size=1M]
        Capabilities: [dc] Power Management version 2
                Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=0mA PME(D0+,D1+,D2+,D3hot+,D3cold-)
                Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=2 PME-
        Kernel driver in use: e100
        Kernel modules: e100

dmesg

[   97.081022] 0000:02:04.0: Missing Free firmware (non-Free firmware loading is disabled)
[   97.081293] e100 0000:02:04.0 enp2s4: CPUSaver disabled. Needs "/*(DEBLOBBED)*/": -2
[   97.101034] 0000:02:05.0: Missing Free firmware (non-Free firmware loading is disabled)
[   97.101214] e100 0000:02:05.0 enp2s5: CPUSaver disabled. Needs "/*(DEBLOBBED)*/": -2
[   97.102838] e100 0000:02:05.0 enp2s5: NIC Link is Up 100 Mbps Full Duplex

hwinfo --verbose --netcard

10: PCI 205.0: 0200 Ethernet controller                         
  [Created at pci.386]
  Unique ID: uy4f.gBruFhIYX46
  Parent ID: 37TO.utJYbPkKj7F
  SysFS ID: /devices/pci0000:00/0000:00:10.0/0000:02:05.0
  SysFS BusID: 0000:02:05.0
  Hardware Class: network
  Model: "Compaq NC3134 Fast Ethernet NIC (dual port)"
  Vendor: pci 0x8086 "Intel Corporation"
  Device: pci 0x1229 "82557/8/9/0/1 Ethernet Pro 100"
  SubVendor: pci 0x0e11 "Compaq Computer Corporation"
  SubDevice: pci 0xb163 "NC3134 Fast Ethernet NIC (dual port)"
  Revision: 0x08
  Driver: "e100"
  Driver Modules: "e100"
  Device File: enp2s5
  Memory Range: 0xe9201000-0xe9201fff (rw,non-prefetchable)
  I/O Ports: 0x2800-0x283f (rw)
  Memory Range: 0xe9100000-0xe91fffff (rw,non-prefetchable)
  IRQ: 11 (5295 events)
  HW Address: 00:02:a5:8e:cf:b5
  Permanent HW Address: 00:02:a5:8e:cf:b5
  Link detected: yes
  Module Alias: "pci:v00008086d00001229sv00000E11sd0000B163bc02sc00i00"
  Driver Info #0:
    Driver Status: e100 is active
    Driver Activation Cmd: "modprobe e100"
  Driver Info #1:
    Driver Status: eepro100 is not active
    Driver Activation Cmd: "modprobe eepro100"
  Config Status: cfg=new, avail=yes, need=no, active=unknown
  Attached to: #14 (PCI bridge)

13: PCI 204.0: 0200 Ethernet controller
  [Created at pci.386]
  Unique ID: Rnqa.gBruFhIYX46
  Parent ID: 37TO.utJYbPkKj7F
  SysFS ID: /devices/pci0000:00/0000:00:10.0/0000:02:04.0
  SysFS BusID: 0000:02:04.0
  Hardware Class: network
  Model: "Compaq NC3134 Fast Ethernet NIC (dual port)"
  Vendor: pci 0x8086 "Intel Corporation"
  Device: pci 0x1229 "82557/8/9/0/1 Ethernet Pro 100"
  SubVendor: pci 0x0e11 "Compaq Computer Corporation"
  SubDevice: pci 0xb163 "NC3134 Fast Ethernet NIC (dual port)"
  Revision: 0x08
  Driver: "e100"
  Driver Modules: "e100"
  Device File: enp2s4
  Memory Range: 0xe9200000-0xe9200fff (rw,non-prefetchable)
  I/O Ports: 0x2400-0x243f (rw)
  Memory Range: 0xe9000000-0xe90fffff (rw,non-prefetchable)
  IRQ: 9 (16412 events)
  HW Address: 00:02:a5:8e:cf:b4
  Permanent HW Address: 00:02:a5:8e:cf:b4
  Link detected: no
  Module Alias: "pci:v00008086d00001229sv00000E11sd0000B163bc02sc00i00"
  Driver Info #0:
    Driver Status: e100 is active
    Driver Activation Cmd: "modprobe e100"
  Driver Info #1:
    Driver Status: eepro100 is not active
    Driver Activation Cmd: "modprobe eepro100"
  Config Status: cfg=new, avail=yes, need=no, active=unknown
  Attached to: #14 (PCI bridge)

Write below your motivation

El contenido de esta página está en Dominio Público. (vea la página CC0 para información detallada). Cualquiera es libre de copiar, modificar, publicar, usar, vender o distribuir el texto para cualquier propósito, comercial o no comercial, y por cualquier medio.
h-node.org is a hardware database project. It runs the h-source PHP software, commit cdeda15, available under the GNU General Public (GPLv3) License.
JavaScript license information