Notice: the text in red has been deleted from the previous revision, the text in green has been added in this revision and the text in gray has not been changed.
differences in the entry: vendor
MosChip-Semiconductor-Technology-Ltd.
differences in the entry: model name
PCI 9815 Multi-I/O Controller
differences in the entry: possible other names of the device
MCS9805
MCS9815
MCS9820
MCS9835
MCS9845
LSI Logic / Symbios Logic 2P0S (2 port parallel adaptor)
differences in the entry: subtype (laser, inkjet, ..)
pcmcia-controller
differences in the entry: VendorID:ProductID code of the device
9710:9815
differences in the entry: year of commercialization
not-specified
differences in the entry: interface
PCI
differences in the entry: GNU/Linux distribution used for the test
debian
differences in the entry: tested with the following kernel libre
4.19.0-arch1-1-ARCH
differences in the entry: does it work with free software?
yes
differences in the entry: free driver used
parport_pc
differences in the entry: Description
MCS9805, MCS9815, MCS9820, MCS9835 and MCS9845 PCI Serial / Parallel ports on Linux platform.
[p]
The parport_pc driver does not always load properly and specific options must be passed using modprobe in order for the card to work properly. See the following PDF for more detailed instructions instructions: [a]http://www.asix.com.tw/FrootAttach/driver/MCS98xx_Linux_Driver_Installation_Guide_v100.pdf[/a]
[/p]
[p]
[a]www.drivers-download.com/Drv/MosChip/MCS98xx/MCS98xx_Linux.pdf[/a]
[a]http://www.asix.com.tw/FrootAttach/driver/MCS98xx_Linux_Driver_Installation_Guide_v100.pdf[/a]
For example, in order A file can be created inside /etc/modprobe.d to get the LSI Logic / set parport_pc options at each boot. My Symbios Logic 2P0S (2 port parallel adaptor) I had to first run
lspci -v
04:04.0 Communication controller: MosChip Semiconductor Technology Ltd. PCI 9815 Multi-I/O Controller (rev 01)
Subsystem: LSI Logic / Symbios Logic 2P0S (2 port parallel adaptor)
Flags: medium devsel, IRQ 7
I/O ports at c050 [size=8]
I/O ports at c040 [size=8]
I/O ports at c030 [size=8]
I/O ports at c020 [size=8]
I/O ports at c010 [size=8]
I/O ports at c000 [size=16]
Kernel modules: parport_pc
I then had to create takes the following file: /etc/modprobe.d/01-MCS98xx.conf
#
# Special settings for the MCS98xx parallel driver options to work correctly on my machine:
# [/p]
########################################################################### [p]
Note: My card has 2 parallel connectors, so I had to reference both I/O port addresses for both ports to function.
The contents of this page are in the Public Domain. (see the
CC0 page for detailed information). Anyone is free to copy, modify, publish, use, sell, or distribute the text for any purpose, commercial or non-commercial, and by any means.
